Quick Start Guide

This guide explains how to mount, connect, and use MFD Touch with a compatible VBOX system.

Mount the unit securely using the supplied suction mount.
Position the display so it’s clearly visible during use.

For permanent installations, use the rear ¼-20 UNC thread.

Use the supplied RLCAB005-C cable to connect MFD Touch to your VBOX unit.

• Connect to the bottom CAN port on the MFD Touch
• Connect the other end to the appropriate port on the VBOX unit.

If you are using a CAN Hub, connect MFD Touch to the MFD port.

MFD Touch is powered through the VBOX connection.

When the system powers on:

• A splash screen appears while the unit boots
• “Waiting for VBOX” is displayed while the VBOX unit is starting.
• Live data appears on the screen when the VBOX unit is ready.

Insert a FAT32-formatted SD card into the left side of the display.

This SD card is used for:

• Store display settings
• Save test results (where supported)

The system is ready when:

• Live data is visible on the display
• Values are updating in real time
• No “Waiting for VBOX” message is shown

For reliable operation, ensure:

• GNSS has a valid lock
• An SD card is inserted
• The system has fully booted

Logging is done by the connected VBOX unit.

• MFD Touch displays the logging status
• You can start or stop logging from the display (where supported)
• Logged data is saved to the VBOX storage media, not the MFD Touch

Once set up, MFD Touch will:

• Display live data from the VBOX system
• Allow you to switch between display screens
• Show logging status and system information

• Full Documentation for MFD Touch
• Troubleshooting
• Contact Racelogic Support